One Amplifier – One Transducer
A basic Shipsonic 10 unit kit consists of a single Transducer connected to a single
Mounting the transducer:
The transducer(s) should be placed below the water line at the bottom inside the
Make sure that you do not site the transducer on any false floor or internal skin.
It is very important that it is mounted on the actual external part of the hull (polyester).
A location within 1-1.5 meters of the propeller(s) or drive unit(s) will help to
keep this clean within the effective area of the transducer.
In some situations it is more practical to use a combination of f.e. 1x Shipsonic
10 unit together
with 1x Shipsonic 20 unit. Of course you can call or mail us to find the most practical
and effective solution concerning the inside situation in you yacht.
One Amplifier – Two Transducers
A basic Shipsonic 20 unit kit consists of two Transducers connected to a single Control
One Amplifier – Three Transducers
A basic Shipsonic 30 unit kit consists of three Transducers connected to a single
Coverage installed inside the hull up to about 20 meter waterline length.
Coverage installed inside the hull up to about10 meter waterline length.
Coverage installed inside
the hull up to about 30
meter waterline length.
the hull up to about 40